Watch Sizing Guide

 

Follow these steps on how to adjust your watch band by removing or adding links:

Step 1: Place the watch band into the watch link tool, ensuring the pin you want to remove is aligned with the pin pusher.

Step 2: Make sure the watch band is level with the pin by spinning the platform to raise or lower it as needed.

Step 3: Tighten the tool by turning the knob to secure the band in place.

Step 4: Turn the tool’s knob clockwise to push the pin out of the link in the direction of the arrow. Be careful not to apply too much force, as this could damage the pin or the band.

Step 5: Once the pin is partially out, use a pair of pliers or your fingers to completely remove it. Set the pin aside in a safe place.

Step 6: To remove the link, simply slide it out of the band. If you need to remove additional links, repeat steps 2 through 5.

Step 7: To reassemble the watch band, align the remaining links and insert the pin back into the pinhole. Use the tool to push the pin back in place, turning the knob counterclockwise this time until the pin is fully inserted. Or, press the watch pin against a hard surface until it’s fully inserted.

Step 8: Ensure the pin is securely in place by gently pulling on the links.